#Cheap tc contender barrels serial numbers

The pin should be a light press fit in the barrel lug, and a drag fit in the frame. If the hinge pin slides through with no appreciable resistance it's way too loose, IMHO. If your headspace is excessive for all three barrels, you may well have a stretched frame. A quick functional check of headspace is to simply fire a primed but unloaded shell, and the look at the primer protrusion afterward. Next question is how much clearance you have with a cartridge in the chamber. That's about the same barrel-to-frame clearance that my Gen 1 has with both my. It would take a lot of shooting to wear one out and the odds of getting 3 worn out ones are poor. If the bbls are in good condition (no rust or damaged crowns) you should easily get 2' groups at 50 meters. It is doubtful that you have worn out bbls. I have seen iron sights from the factory that had screws too long too but it is much more common to see it in scope bases.

Once you have that screw good back it out and do the same thing with the next until you have all 4 the right length. If you can shorten the screw 1 thread and try again. You should not be able to wiggle the base AT ALL.

You can do this by loosening all the screws and tightening one down all the way. Make sure your base screws are not bottoming out before your base is tight. Will certainly kick loose a mount that was not tightened properly. The 44 and 30-30 are kickers, especially in the 10' bbl lengths. If you have a gross amount of slop in either the only cure is an over sized pin.ДЄlso check your scope mounts if you are using a scope. The pin will probably slid through with no resistance but if you can get noticeable side to side movement that is bad. It should not have any noticeable wiggle in either the bbl hole or the frame holes. If you have some slop in the lockup check your hinge pin. This is probably not the cause because you said your having problems with all 3 bbls but it is worth checking. Are the locking bolts on your bbls all blued? Over sized bolts are left in the white by TC. This would not be caused by stretching but by under/over sized locking bolts. How is the bbl lockup? If you get any movement at all when it is closed that can be an accuracy killer. Extreme cases will show maybe a 1/8' stripe. Stretching will look like a light line in the blueing. That is the notch that is just in front of the breech face.

The stretching will occur in the cut that allows the locking bolt rollers to pass down into the table. You can see this by looking down into the internals of your frame when the bbl is off.

To check and see if your frame is stretched you need to look for a 'stretch' mark inside the frame. 209x50 G2 Contender Barrel will NOT fit on any original Contender frame.003 is not an uncommon amount of frame/bbl gap.

#Cheap tc contender barrels serial numbers

Forends: rifle shotgun and muzzleloader barrels use different forends.Contender and G2 Contender Compatibility: ONLY Contender frames with serial numbers greater than 195000 are compatible with G2 Contender barrels. All Contender barrels will fit blued and stainless barrels are interchangeable. Barrels for the G2 Contender can be changed in only minutes by removing the forend and tapping out the barrel/frame hinge pin. In addition to the 40 barrel choices to match the accuracy and caliber range of any hunt the G2?s grip frame and forend have been profiled and sculpted for a modern streamlined appearance. The second-generation G2 Contender is even more user-friendly in the field than Thompson/Center?s original Contender. G2 Contender Barrel Blued With simple barrel interchangeability time-proven long range accuracy and adaptability between rimfire and centerfire the versatility of the G2 Contender is unmatched by any other interchangeable platform in the world.